Anycubic Photon Mono Resin Drip Platform Holder

thingiverse

I made this to help remove more resin from my prints. It seams there is still so much resin on the models after printing even though it has been hanging upside down for a while. This clamp holds the platform at a 90 degree angle from the vat. This helps let more resin fall off the print into the vat. Some of the models I print hold a lot of resin. I love this design. I find very little resin left on the model after it has been hanging in these two positions. CAUTION: Do not try to use this holder for a model more than about 100mm tall. The resin will miss the vat. Please double check.