Anycubic Wash & Cure Plus Adjustable Hanger

thingiverse

I needed a hanger to cure a particular trim piece I have been making and wanted it to be versatile. So it's a 3 piece unit with adjustability for max height inside the lid, to the lowest setting just clearing the fold over light frame for shorter prints. Notches in the lower section indicate the positions where you can screw in the two locking bolts (finger tight) to hold the upper section in place. Also made to clear Herr Rossi's turntable holder. ( https://www.printables.com/model/377577-drehtellerhalter-fur-anycubic-wash-and-cure-plus ) Please take note of the screen shots of slicing orientation as this is how it was designed, for strength and minimal supports. The "W&C_Plus_Insert" file will need supports around the square shaft and "W&C_Plus_Hook_Lower" will only need supports in the square cutout. I have also included the Fusion 360 file for the insert incase anyone needs to edit dimensions to fit on the motor shaft. It does need to be a snug fit so the hanger doesn't tilt backwards without weight on the hook. Designed to use two M6x10 bolts (only had 15mm to assemble mine) and standard hex nuts but the top piece may need warming up or trimming to insert the nuts. I also glued mine in place along with gluing the insert into the lower section. I would recommend either making this in ASA (as its UV resistant) or painting it for long term stability. But PLA would be fine for occasional use. Please let me know if any changes need to be made to the files. Thanks!