Aomway Antenna protector

thingiverse

I created this Aomway antenna cap trying to get the smallest possible, yet (almost) indestructible protector for the famous and widely used Aomway 5,8 GHz circular polarised antennas. You have to print the top piece once, the bottom piece twice and assemble them as you can see on the images. Afterwards you should put a cable tie around the middle of the bottom pieces to hold them together and firmly on the antenna shaft. Even if the caps snap together and stay that way without any glue, I prefer putting some drop of glue between the top and bottom pieces, because you can loose the cap in a hard crash otherwise. Thanks to Philipp Seidel (http://blog.seidel-philipp.de/) for his design which inspired mine a lot! If you speak german and are an FPV pilot - check out his blog. Feel free to print and use the model, but I do NOT consent to anyone selling them in order to gain any money. Only personal and no commercial use of my 3D model.