Apple Watch Dock

prusaprinters

<p>NOTE: This design is for the Apple Watch Series 5 44mm version.</p><p>Simple Apple Watch dock, inspired by several others floating around but this one has an enlarged base to hold weights to keep it from tipping over. I used metal weights from an old remote control dock but you could also use washers or anything else you can fit into the space. Just be sure to glue or tape them so they don't rattle.</p><p>The base is secured to the top using three screws and heat press mental inserts in the top. The base holes are bridged for printing without supports and need to be drilled out post printing. STEP files are supplied if you want to edit. Several parts may depend on the tolerance of your printer.</p><p>I added some rubber feet to the bottom to stop it sliding around. So far working very well and not as easy to knock over in the dark as an unweighted stand.</p><h3>Print instructions</h3><h3>Licence: Creative Commons - Attribution - Share Alike Category: Gadgets Print Settings</h3><p><strong>Printer Brand:</strong> Prusa</p><p><strong>Printer:</strong> I3 MK3S</p><p><strong>Rafts:</strong> No</p><p><strong>Supports:</strong> No</p><p><strong>Resolution:</strong> 0.2mm</p><p><strong>Infill:</strong> 15%</p><p><strong>Notes:</strong></p><p>Printed in PLA without any issues but most materials should be suitable. If printing in a material that is prone to shrinkage additional tolerance may need to be added.</p>