Apple Wireless Keyboard case

prusaprinters

<p>I designed this case for the Model A1314 Apple Wireless Keyboard third generation but it will probably fit others. If there is interest I could do one for the Magic Keyboard. I designed it to be compact, add a fair amount of protection and not use too much filament.</p> <p>WARNING...this will only work if the printing instructions are followed. It is a thin wall design using a solid model. Important, one of the two sides will need to be mirrored before slicing.</p> <p>The print time per side is 4hr 19min. Each side uses 10.81m, about 32g. The size on the print bed is 114.4x105.3x154</p> <h3>Print instructions</h3><h3>Category: Computer Print Settings</h3> <p><strong>Printer:</strong> Anet A8</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> 0.25mm</p> <p><strong>Infill:</strong> 0%</p> <p><strong>Notes:</strong></p> <p>Using Cura 2.3</p> <p>Mirror one of the two pieces prior to slicing.</p> <p>Shell<br/> -wall line count, 1<br/> -Top Layer, 0<br/> -Bottom layer, 4<br/> Infill<br/> -0%<br/> Material<br/> -Print Temperature, 183C<br/> -Build Plate Temperature, 60C<br/> -Flow, 108%<br/> -Enable retraction, yes<br/> -Retraction distance, 4.5<br/> -Retraction speed, 60mm/s<br/> Speed<br/> -Print, 30mm/s<br/> Travel<br/> -Combing mode, off<br/> Build Plate adhesion<br/> -Skirt, yes<br/> -Count, 4<br/> -Distance, 2<br/> Mesh Fix<br/> -Keep disconnected faces, Off</p>