Apprentice Tail Skid ROUGH SKETCH / PROTO 000

thingiverse

I roughly sketched this part following a request below. Hi Dennis, I don't "have" the part you're looking for because at that time when I made the tailbracket, I didn't need the skid on the bottom. Unfortunately, I don't have the part you need lying around, so I cannot make any precise measurements. So what I did: I used the bracket [thing:1427287], which I designed and published earlier, to take the measurements from that and "guessed" a bit about what this underside might look like. So what I'm publishing now is a very rough sketch based on a different part that might point you in the right direction. Feel free to mess around with it until it fits your needs. The part being published comes in the format used by Autodesk Fusion 360, which is a very capable software freely available for both students and hobbyists. Give it a try and you'll be surprised at what you can do! Note that this is just a prototype; I haven't printed it yet. Try it out and adjust it to fit your needs.