Aquarius zodiac sign stencil / multicolor

myminifactory

3d model of aquarius zodiac sign For 2 color image, print the file (1-aquarius infill.stl) first following these instructions:1-load the file in slicer. 2-scale the x and y dimensions of the model (I used 500% for both)3-flip the model in the slicer so it's facing upside down.4-set the X and Y position to (0,0) respectively in the slicer to center the model on the bed5- set the Initial layer height to 0.2mm (very important)6- print and when done keep the print on the bed (do not remove), heat the bed and nozzle and change the filament to another color next print the file (2-aquarius-stencil.stl)1- load the file 2-scale the x and y dimensions to the same value of the first file3- flip the model upside down4-set X and Y position to 0 and 05- set initial layer height to 0.2mm6- delete the first model (1-libra Infill.stl) if it is still present7-print the model with a different color next print the file (3-aquarius-backl.stl) to add strength to the print 1-load the file 2- scale x and y to same value of the other 2 files 3-flip the model 4-set x and y position to 0 and 0 5-set initail layer height to 0.2 mm 6- delete the previous model 7- print the model NOTE : to reduce print time, print the third file with a larger nozzle (change the nozzle and re level the bed with the previuos models remaining on the bed) and in slicer set the initial layer height to 0.2mm (very important) and set the layer height of the remaining layer as you desire ( I use 0.4mm layer height) this step has reduced print time of the third file from 6 hours to about 1 and a half for me