AR Wing Insta360 One X "Rhino" mount

thingiverse

This mount fits into the camera cage on the AR wing and attaches via velcro to the rear platform, velcro straps through the middle and self tapping central screw at the bottom. You will need to cut a section out of your nose cone at the top to be able to push fit the nose cone. Printed in PETG for strength. You should be able to lift the whole wing by holding the insta360. Use 3mm screws and locking nuts for attaching the 360 mount. Pliers may be necessary to hold the locking nuts while tightening. Careful tightening as it will split the PETG if too tight. (possible design change needed here). Top mount can be printed in PLA which seems to be strong enough for the job and I've flow successfully like this.