Archangel

cults3d

I printed on FDM ender 3 printer Model content: Archangel-body(56mm) Archangel-chains(161mm) - I printed this option, probably it is weak for me, I think to strengthen it with epoxy resin, I advise you to print the second option or print this only with some kind of strong plastic Archangel-chains-ver2(163mm) Archangel-cloak(142mm) Archangel-hands(59mm) Archangel-jatpack(38mm) Archangel-left-leg(103mm) Archangel-left-wing - Pay attention, support is printed high in one place, I turned it so that I could reduce the number of supports, make the support settings thicker so that it could reach, or rotate the model as you need. Archangel-right-leg(89mm) Archangel-right-wing - Pay attention, support is printed high in one place, I turned it so that I could reduce the number of supports, make the support settings thicker so that it could reach, or rotate the model as you need. Archangel-stand(176mm) Archangel-stand-with-pazzle(176mm) Archangel-sword(100mm) Archangel-sword-2(97mm) -----------------------sword-------------------------- hand(86mm) sword(170mm) - I printed at an angle of 60 degrees to reduce vibration sword-with-fire(175mm) There are print defects in the photo, this is a printing problem and not a model.