Arduino Nano v3.0 Casing

thingiverse

This is another straightforward design for the Arduino Nano v3.0... (without header pins). Dimensions are 25x25x50 millimeters. A large hole accommodates the old USB port, while a smaller one holds a couple of signal wires. The holes are threaded for M2 bolts. Note on files: - **ardunanobox_bottom.stl** - The USB hole is too low and too small: the USB socket won't fit when placing the nano in position. - **nanocasing_bottom_v1.1.stl** - Fixes issue with USB hole. - **ardunanobox_top.stl** - casing top, 10mm high - **nanocasing_top_lp_v1.1.stl** - casing top Low Profile: 5mm high 2019/11/12 - Added a top casing with housing for one or two push-buttons (6x6x5mm) - **nc_toplow_wBtn.stl** single button - **nc_toplow_w2Btn.stl** double button. To install buttons, simply: 1. Solder wire to 2 of the button's pins. 2. Install the button in its hole. 3. Fold the pin of the button against the inner wall of the top (optional: Apply hot glue before installing button in its hole - This can be a messy process, as hot glue rarely stays where you want it to.)