Arduino Starter Kit Base Replacement

thingiverse

This was created to replace the original wooden base that the Arduino Uno & breadboard were to be secured to in the Starter Kit. Do to a poor original design, the base would tend to break if too much pressure were placed in the center. Also, the breadboard was only supported by the double sided tape which allowed the metal rows to push through from the underside. This has full support across the back side. Print Settings Printer Brand: MakerBot Printer: MakerBot Replicator 2 Rafts: Yes Supports: No Resolution: .2mm Infill: 20% Notes: The infill is at 20% to add a little more strength. How I Designed This Measured the original rounding to the nearest mm.