Arduino Uno case

thingiverse

This design is tailored for the Arduino Uno Rev1 and Rev2, with compatibility also extended to Rev3 though not all pin connectors may become accessible. The hardware requirements include M3 screws measuring 26.2mm in length including the head. The printer settings employed were those of the Geeetech i3 Pro B, featuring rafts set to "No" and supports enabled for optimal stability. A resolution of 0.2 was chosen, with an infill density of 30% achieved through efficient layering. Key printing parameters include a first layer height of 0.3mm, layer height maintained at 0.2mm, and layer width set to 0.51mm for enhanced structural integrity. Four perimeters were selected in the slicing process, with the option to consider three perimeters as an alternative for potentially better results. The slicer utilized was Slic3r version 1.2.9.