Arduino Uno + SmartThings Arduino Shield Enclosure

thingiverse

Arduino Uno + SmartThings Arduino Shield Enclosure This enclosure is printed in 2 parts. There is a base component that will allow one to pressure fit (no screws to hold down- strictly a friction fit) an Arduino Uno Development board. Then there are 2 version of the upper cover. One that has flexible tabs modeled in that allow one to press the plastic tabs down to either actuate the PAIR or RESET buttons that are found on top of the SmartThings Arduino Shield. https://shop.smartthings.com/#!/products/smartthings-shield-arduino Update: It appears Smarthings no longer sell the Smarthings Shield. Link above no longer points to the shield device. The other upper cover has not tab cutouts for accessing the buttons on the SmartThings shield and just provide complete coverage. Both upper covers slide over the base and click into place with small tabs at the bottom of the enclosure. This enclosure offers 2 tabs on each corner to facilitate wall mounting. Print Settings Rafts: No Supports: No Resolution: .3 mm Infill: 40 % Rectilinear Notes: Printed using .3 mm 40 % infill (rectilinear) How I Designed This Modeled using SketchUp 2014 Modeled using SketchUp 2014. Borrowed measurements for the base component from James Eckdahl. http://www.thingiverse.com/thing:713091 Upper Cover w / tabs Upper Cover - No Tabs Custom Section Base