Ardunio Uno Stand

thingiverse

This is a small stand for holding Arduino Unos. It has grooves to keep the Arduino off the ground and clips to hold it in place. Instructions (1) Print using default replicator settings. For me, this is: Object Infill: 10% Layer Height: .27mm Number of Shells: 1 Feedrate: 40mm/s Travel Feedrate: 55mm/s (2) I usually like to set the plate to 110 deg instead of 100. (3) Push your Arduino into the stand gently. I had to work at it a few times before I could get the board into the slots reliably, but with a little bit of practice it worked without any trouble. (4) To remove your Arduino, push the clips outward gently and pull your Arduino out