Armillary Sphere

thingiverse

# Armillary Sphere ## Parts needed * 109mm long steel axle with an diameter of 2mm * 2x 682ZZ ball bearings * CA glue ## General hints * I designed this model as a one-time build, so it is not optimized and can require some sanding to make all parts move smoothly * The parts are relatively fine and it can take some skill to align and glue them together * Parts that need to be printed twice have an _2 at the end of the filename * Printing is quite easy for the most part. The only challenging parts are the earth_meridans that are complex, thin and need supports. ## Assembly ### Foot/Holder For the base you need: * Foot_base * 2x Foot_Left * 2x Foot_Right * Foot_Horizon The 4 foots can be sticked and glued in the base. After this the horizon can be applied on top. There are small pins that help you allign the horizon correcly. ### Earth This is the central and rotating part. For this you need * 2x Earth_half * 2x Earth_meridian * Earth_zodiac_ring * Earth_moon_ring and 2x Earth_moon_holder (OPTIONAL: This describes the position of the moon. However it it a little bit challenging to move as it is just layed in the center ring and not really fixed) Glue the earth halves together. Glue the first meridian half globe on the zodiac ring and let it dry. OPTIONAL: Add the moon ring in the center. Then glue in the second meridian half globe on the other side of the zodiac ring rotated by 180 degrees so that the holes of the meridians are opposite to each other. Then stick the steal axle through the first meridian hole, then the earth, the the second meridian hole. ### Sphere This connects the rotating earth with the base and lets you adjust the latitude of your position. For this you need: * 2x Sphere_axle_holder * Sphere_degree_ring * Sphere_time_ring Put the ball bearings into the axle holders. Then slide the holders on the earth_axle, you prepared in the last step. Then you combine it with the degree ring and the time ring. Look at the images for reference. ### Final touches Finally you can sit the complete assembly in the foot holder from the first step and clip the attachment_sun on the zodiac ring