ARTILLERY SIDEWINDER X1 SPOOL HOLDER WITH BEARING

thingiverse

Here my design for the spool holder with bearing or not, that I created for my Artillery Sidewinder X1. I used Fusion 360 to realize this project. Support_v5 and support_v6 are similar but v5 have no logo. ***Re-use existing bolt, fasteners and bearing*** For the arm with bearing, I use the original bearing R1450ZZ took from the Artillery mounting spool bracket. Also You can use 605ZZ Shielded Ball Bearing. The bearing inner diameter is 5mm, outer diameter is 14mm and width is 5mm. ARM_BEARING_V2, ARM_BEARING_V2.1 and ARM_BEARING_V2.2 share the same design with a different length. They have a main shaft with bearing at the end. ARM_BEARING have bearings sit on pins **SHAFT_BEARING_V2.1 go with ARM_BEARING_V2.1 (Short version: 72mm spool width max.)** **SHAFT_BEARING_V2 go with ARM_BEARING_V2 (Long version: 87mm spool width max.)** **SHAFT_BEARING_V2.2 go with ARM_BEARING_V2.2 (XL version: 100mm spool width max.)** **PIN_BEARING_5MM go with ARM_BEARING ( Single version: 77mm spool width max.)** **arm without bearing (Short version: 77mm spool width max.)** **arm_long without bearing (Long version: 87mm spool width max.)** ***XS means stronger version***