Arylic Up2Stream Amp 2.0 Case

thingiverse

**March 29 - Made some changed to the design. Moved Antenna holes a little more toward center away from capacitor. Also made Antenna holes a little larger. Feedback from AVIF. New Case is now Case with IR V2.stl Thanks **March 27 - Uploaded photos of the curent finished product. The case with IR has holes for the external antennas that look way cooler. I also added the cutout for IR and status LED. The top works on either case design. **March 8 - Uploaded new file. Case with IR.stl. I moved the antenna holes to the side and made them large enough to allow the external antennas. I also added a cutout for the IR sensor and Status LED. This is my first ever design. I had to learn Fusion 360 and all the stuff that goes along with creating these things. I am happy with the result. I decided to go with a large open cutout because the two AMP 2.0 boards I have were just a little off from each other. This should make this work for all the boards. I also built this with snap on top cover which I like. For some reason I had to raise the cutout as my prints were off by about 1.6mm. Hope this lines up for you all. I used supports for the cutout window and blocked the supports for the snap on 45 degree angles sections of the case and top. Also print the cover with the top facing down. The case has a area to mount this to the wall. I used CHEPs Magic .20 profile for the print. Took about 5.5 hrs for the case and 2.5 for the cover to print. Like the white. ** I ended up only using 3 screws. The one near the Ethernet seemed just a little off and was not really needed as it was pretty secure with the three. Thanks to Arylic for assistance on my questions. This device is a nice alternative to $ono$. Device info - http://www.arylic.com?aff=38 Full disclosure this is my affiliate link so I get a small omission if you use this. You don't have to up to you.