Asus ROG Phone 3 - Lighting Armor - Outer Case

thingiverse

*Note! This is a case for a case, it will not fit your phone by its self* I found the lighting armor case for the new Asus Rog Phone 3 to be both unprotective and hard to hold on to in general usage. Since I paid so much for the thing I set out to make it a bit more usable. This is what I have come up with so far. This will likely be tweaked and modified over time as I use it more. This must be printed from TPU and is a compression fit. If you somehow break your phone or case due to this object, I take zero responsibility. Different TPU materials have different levels of stretch and flexibility. Some may fit loosely while some may be so tight you would break your case before being able to fit this over it. I personally used the "Make Overhang Printable" and 60* maximum angle in Cura. I was having a terrible time removing supports. If you prefer supports and find it doesn't fit snugly enough, you may try reducing Z scale slightly in your slicer.