Asus ZenWatch 3 Charging Base

thingiverse

This base can hold the little charger ring that comes with the Asus ZenWatch 3 as pictured. The Ring should snap in with a very light pressure fit. Please be very careful with your charger ring and watch. The pressure fit should allow you to pop the ring on the base with just a light press of your finger. Then the cable can be securely tucked into the groove running down the center of the back of the base (as pictured). Troubleshooting: If the fit is too loose then add a one percent increase in size. I don't recommend glueing your charger ring to the base. If the fit is too tight either: subtract one percent from the size or carefully file down the part of the base that snaps into the charger ring. And as always, if you print and use this, please share a picture and your thoughts. Print Settings Printer: Maker Select i3 and PowerSpec Ultra Rafts: No Supports: No Resolution: 0.20 Infill: 20%