ATX Lab bench power supply

thingiverse

Its and add on for ATX power supply ,in files theres stl and fusion files so u can modify it to yours needs u want to cut out te red are with angle grinder and B is thicknes u want to left so later u can glue your print to it it requires 4x M3 bolts for front panel The Volt and Amp screen i used is this one https://amzn.to/3cTB2vY the step up converter https://amzn.to/3cS9O91 10K ohm potentiometer https://amzn.to/2Sbqwsj 4mm banana terminal https://amzn.to/2xUL9SI resistor simillar to the one i used https://amzn.to/2KAzDym fuse holder simillat too because mine are a bit old https://amzn.to/2y7wJym the switch is up to you 2 diodes and 333ohm resistors