(AU) Honda Accord Euro key fob

cults3d

(AU) Honda Accord Euro key fob - made for my 2003 model. IMPORTANT, MUST READ BELOW; I created the original model just over a year ago and the imperfections from my learner days are still present in this model, as it just too much effort to fix, the below is an FYI that addresses this imperfection and suggested fix. There is a ~0.5-1mm gap betweent the actual key and the the circuit board housing which you can you use a piece off the support material to wedge in between. Use a piece of thin double sided tape or blu-tac to stick the "spacer" (recycled bit of support material) on to the key before fitting in the guts of the FOB. Use Zig-Zag support pattern which will give you a small piece of ~0.5-1mm material to cut up to use as the "spacer". This spacer is critical for removing the key from the key barrel as the user is required to 'push' the key 'in' to turn the car off, so if the key slides back into the case ~0.5-1mm it will not allow it the user the turn the key to the off position to remove the key. If you find yourself in this situation you will have to break the 3d print off. the lid will need to be rotated 180o with the Honda logo facing down Don't forget to Pry out the RF Transmitter, your car won't actually start without it, it this tiny detail that cost $100 to replace if done through a Honda Dealer