Aurora A3 Inductive Z Sensor Mount

thingiverse

This is an inductive sensor mount for the JG Aurora A3 printer. Replaces the nylon standoffs under extruder heatsink. Used ABS due to proximity to the heater elements. UPDATE: Had my original mount break on me due to some vertical forces from the sensor running in to things (and bumping it up too many times). Created V2 that is a little beefier and printed with 50% infill. SECOND UPDATE: I've switched from using this mount as I think it is too close to the hot end (even printed in ABS) and generally too thin. I get best (most consistent) results from the sensor when it is as close to vertical as possible ... and this mount just could seem to handle that. Print Settings Rafts: No Supports: No Resolution: 0.2mm Infill: 50% Notes: Rotate to print larger hole facing up and smaller holes horizontal. (V2 pre-rotated and should print as-is)