Autel Nano Controller Pads

thingiverse

Very low thumb pads for replacing the controller sticks, allow storing the controller without removing the pads. Also feel quite nice while flying. You'll need two M4 socket screws, shortened to length. I did not go with a printed thread because threads of this tiny size break far too easy - and you'd curse me forever while trying to pry out the plastic remnants from the internal thread after breaking. Just shorten the M4 screws and press them in with your thumb, no glue required. Important: Print with supports, standing, pad side up, layer height 0.2 mm - if you wish to use lower layer heights, add a generous brim, PLA works fine. Don't use PrusaSlicer - the standard supports generated are just impossible to remove. Simplify3D does a perfect job, other slicers may also work fine. Make sure to remove ALL support remains, otherwise your pads get slanted.