Auto feed annealer using amazon hand held annealer

thingiverse

THIS IS A WORKING PROGRESS. Mine works pretty good and I have minimal hangups but I had to modify a few things by hand to make it run smoothly. I used https://www.thingiverse.com/thing:4902058 this case feeder to feed the system that is driven by the slide motor and a pto, that way you only have 1 motor to worry about and the timing of the whole system is a lot easier with less electronics. You need 1 timer relay 1 relay 2 switches 1 geared motor with 60mmx64mm bolt holes 8mm shaft (found mine at princess auto) 2 u joints 6mm 6mm rod 2 rc plane ball joints Update I have moved the proximity sensor so it snaps into the main body with a updated spacer and made the hole bigger for the gear going trough the main body. I am testing the 223 spacer first and if it works ill upload the rest of them. the new spacer have a bigger funnel to catch the dropping case not that it was a problem on the first design I just wanted to move the sensor so it is not part of the spacer and stays with the main body. UPDATE I haven't tested this with long actions cases it should work. With Lapua Mag you might just have to print a longer ram mount arm to get the clearance. I have tested it with 300blk up to a 6.5 prc