Aviator Sunglasses

prusaprinters

<p>This is a replacement frame for Rayban Aviator lenses (in case your original frame has been damaged). Filament (1.75mm) is used as pin for the hinge. You can use hot water or a heat gun (with caution) if you cannot insert the lenses. The same way you can modify the curve of the temples if you are not satisfied with the fitting.</p> <h3>Print instructions</h3><h3>Category: Glasses Print Settings</h3> <p><strong>Printer Brand:</strong> Prusa</p> <p><strong>Printer:</strong> <a href="http://amzn.to/2rqZ6Uo">Prusa Mk2</a></p> <p><strong>Supports:</strong> Yes</p> <p><strong>Notes:</strong></p> <p>For the best printing result it is advised to use PVA for support material. Otherwise, it is important to use the suggested settings below.</p> <p>Cura Settings (for the frame)<br/> Layer Hight : 0.1mm ( or 0.06mm)<br/> Support : Yes<br/> Support Density : 20%<br/> Support Z Distance : 0.2mm<br/> Support Horizontal Expansion : 0.5mm<br/> Enable Support Interface : Yes<br/> Support Interface Thickness : 0.4mm<br/> Support Interface Density : 100%<br/> Brim : 1mm (for the frame, if you have adhesion problems)</p> <h3> Post-Printing</h3> <p>Use a piece of filament (1.75mm) as a pin.</p>