AyUp to QuadLock Out-In-Front Adapter

thingiverse

Made this to fit my Ay Up Lights to the underside of the QuadLock Out In Front phone holder. UPDATE 8/5/23: Created a v4 to address some issues after a few months of wear. v4 now relies on the plug arm to prevent wobbling in the mount. You can also turn the mount up to 60 degrees to cater to QuadLock mounts not being 100% straight, which causes directional lights to point off centre. Finally, you can use the mount front or rear facing, the benefit of this is the back of the mount will rub against the lights and reduce movement for lightsets that have become floppy with age. There are THREE types, two longer and one shorter. Take your pick, but recommend the latest verison. Currently v4. Requires two 6mm M3 bolts. There are two bolt types, counterbore, for flat head bolts, and countersink for tapered head screws. Pick the one best for your needs. Recommend v4 which uses flat. I have only ridden a few hundred kilometres with my designs so far, so not sure how longevity will go, but I have tweaked them a lot of create what I think will be the most reliable fit and function. That said, I am a beginner, so any suggestions to improve - Im all ears. Let me know how it goes for you. NOTE: I printed with walls 7 lines thick in Cura using the 'CHEP Good' profile with good success. This helps with additional material at the thinner areas around the plug. I printed in PLA. For v4 use Tree supports. When removing v3 versions, I suggest twisting the plug out of its socket first, and lifting vertically out of the mount. v4 seems more reliable. Id love your comments and improvement suggestions.