B-Robot EVO 2 enhanced chassis for 2 servo arms

thingiverse

I've been searching for some time for a 3D printable chassis to fit a 2nd servo arm in my B-Robot. But the very few designs that i've been able to find do not actually have the correct dimensions so it turned out to be a waste of time and printing material. So, i decided to design my own based on the original B-Robot EVO 2 design. Personally tested! :) You can use the same side panels from the original design, as the height of the robot stays unchanged. This modified chassis also needs the same number and type of screws and nuts, so you can re-use the other parts that you already have from the kit. There are only 3 new parts to print for the wider chassis without requiring any other additional components: the motor plate, the electronics shelf and the top plate (optional). UPDATE: I fixed the nut cutouts in the electronics and top plates to make them just a little bit wider so it's not too tight to put the nuts through anymore. 3D printed and tested by myself. I also attached a picture of the slightly updated electronics plate with the four nuts installed. :)