Baby Gate hinge for Regalo Baby Gate

thingiverse

Had to get creative here, Regalo baby gate hinge broke. Took a couple tries, but now its fairly tough. As you can see from the picture, our house can be a bit...exciting...at times. So the original hinge snapped clean off. This has since taken its place and is holding well. Recommend to NOT print in PLA, PETG is a much better choice for this application. The PLA version lasted 2 days. The PETG version in the picture has been there for quite a few months now and is holding strong. I printed it pretty hot for higher strength. Although PETG becomes stringy at these temps, it was worth the clean up in the end.