back_panel_raspy_MPI3508_V2

thingiverse

I had to remix the back plate from the original creator as it wasn't letting my screen line up to hide the bezzle on the USB side of the PI. this was modified by 2mm each end to allow the pi and screen to move over to the end (i had to move out part of the metal thats around the USB on the pi for it to fit between the gap) This was for a MPI3508 touch screen on a Pi3b+ GPIO pins and the HDMI plug. Fewy issue i had with this design was the screw hole for the Prusa i3 MK3S+ screen that sits just down from the PI was off by around 2mm, I ended up just using a self tapping m3 screw that resolved that issue but may be worth a tweak. (i didnt feel the need to re print it all for just that. I used an angled down 90 degrees' USB cable into the Buck converter but this was still too low and was not allowing the unit to fit flat. I ended up printing 4 28mm extensions to use as part of this design. These can be found here: https://www.prusaprinters.org/prints/31852-rubber-feet-extenderraiser Will add pics shortly.