bad dragon and DIT silicone sleeve, adjustable angle desk mount. v2

thingiverse

It holds your favorite soft shell sleeve so you can use it while watching vids or viewing VR content. :P The item uses about a 1kg roll of PLA filament. All parts can be printed with low infill and perimeters due to small triangles set at stress points. almost all breaks can be fixed with application on PLA from a 3d pen, resulting in a stronger point than before. its highly recommended that you melt edges and round them off. A printed washer in the middle of the project need to be coated with hot glue to help increase friction or the mount will not hold its angle. Individual parts are printed with cheap badly calibrated printers in mind, so if you own a well calibrated printer you may have to resize parts up to 2 mm in order to get a tight fit. The screw and thread part will work fine even when it is very lose. But the 16mm dowel is best used with a small hole that is warmed up to get a tight fit. tools required jet lighter 3d pen. (needs to be the abs/pla extra hot type) https://www.ebay.com.au/itm/3D-Printing-Pen-LED-Screen-Crafting-Draw-Printer-PLA-ABS-Filament-pb4/302603229056?hash=item46748ed780%3Am%3AmIJmYS_WaH3vjlGG-gLygmA&var=601441920896 3d printer. materials required thick rubber bands. m10 100mm bolt and nut. 16mm dowel. hot glue (but you can use a jet lighter, you don't need a glue gun) I take no responsibility for injury, damage to members or property.