Ball in cage revised

thingiverse

I like to fix things. So I fixed this: reoriented for better print. fixed inside of roof to be an inverted pyramid so you do not get a mess when printing the overhang (as much) sculpted it a bit to save plastic and add a little more artistry. Enjoy. Rev 2 A little stronger arms (rev 1 worked but is fragile higher res sphere (the original one was way too blocky) New sphere shaped indents in top and bottom to preven ball from sticking. Rev 3 After a tip cleaning, I found that the ball sticks too well to the base when printing so added a little bump to move it up slightly. Recommend scaling by 1.25 (125%) for a good strong print. Enjoy again!! Instructions Just print it - scale to 1.25 (125%) for good strength Run a thin hobby knife between the ball and uprights to loosen the ball from the sides, Break ball loose from the base (pry up from all sides) Amaze friends at the "impossible" thing. ;-)