Banana Test Lead Holder

prusaprinters

<p>This was created out of frustration with the typical test lead holder that uses fingers, the test leads would fall off and it would take a while to figure out what was available from the rats nest underneath. This has resolved my issues and puts a smile on my face when I need to run a test.</p><p>You can mount this with wall anchors or adhesive just keep in mind that it can get quite heavy fully loaded.</p><p>Printed with PLA,&nbsp;.4mm nozzle, .2mm layer height, 4 vertical and horizontal shells with 15% Gyroid infill.</p><p>The anchor model is from McMaster item # 66615A21, it's designed for a #8 screw but a #6 should work as well.</p><p>No supports required!</p><p>Models import in the intended printing position.</p><p>MMU - There are two models for different colors - bananaTestLeadHolder_MMU_base and bananaTestLeadHolder_MMU_top.</p><ul><li>Top features are flush</li></ul><p>Non-MMU - There is one model - bananaTestLeadHolder_manualSwap.</p><ul><li>Filament is swapped to a different color at 15.2mm, top features are raised</li></ul>