Band clamp corners for paracord

thingiverse

Still printing. Lately, I'm making simple frames out of 1x2 cedar. These frames are big though... 3ftx8ft in size. Out of all the options out there, I felt a band clamp would work best in this situation. Designed to use your typical 6mm/1/4" paracord. Paracord is fully captured and given deep grooves to live in. Added a corner relief cutout. Added a flat and a notch that intersects where the corner should be. These are to catch the edge of your tape measure when you check for square no matter what orientation you're in. Be sure to add a layer or two of masking tape to the inner bottom triangular surface or your glue squeeze is going to stick.