Bandsaw guide

thingiverse

I made this on SketchUp and then printed it out. the circle part that goes around the bar is a tight fit and may need to be sanded. it is made for a 3/4 pipe or steel bar that comes with the bandsaw. the holes are made to have to screw that were with mine to just thread in. the back clamp is made for a 1/4-20 bolt and nut. I drilled mine out, so the screw slides into the clamp hole easier. I also increased the clamp so i should work with 7/8 pipe that some have on their bandsaw. I also had to trim the guard some because of a measurement didnt line up right in the middle of the bolt for the blade guard.