Bar Clamp 30mm

thingiverse

This is a simple 2 part bar clamp that was part of another design I am making. Figured i would post it here as a template for anyone who wants to make somethig that needs a bar clamp. This clamp is designed for a 30 mm bar. It uses four #8 nuts and four 1 inch long 1/8'' machine screws or hex bolts. If you like this then check out my microphone mount for my monitor stand that this piece was made for! Should print standing up with no supports but you will probably want to print with a raft or brim depending on your build plate adhesion since there isnt much surface area touching buildplate. Probably best at 0.15 layer height but will probably do fine at 0.2 layer height as well. PLA would be fine but if it will be used in a car or outside in the sun all day i would try PETG.