Base for Bosch Colt Trim Router

thingiverse

I designed this base to clamp onto a Bosch Colt Trim Router. I needed a base that was farther away from the end of the bit for a project I am working on. This base is meant to be moved by hand. I included four stl files that chronicle the development process routerring.stl is just a quick single wall, 10% infill test print to make sure I measured and printed the correct diameter for the girth of the router body. routerclamp.stl is just the clamp geometry around the router. This was printed to test my implementation with 6-32" x 1-1/2" long screws, 6-32 washers, & 6-32 nuts. This can be used to adapt this geometry for other purposes. routerclamp-holetest.stl is a piece of the router clamp file to experiment with printing the horizontal holes without structural support, and to test the best print speed. routerbase.stl is the final design.