Baseplates 6inch Actionfigures Star Wars Logo

cults3d

These are stands for 6" action figures. I made the baseplate and the little pins as seperate parts, because if you simple print the plate with pins on top they easily break. Attention: Action figures not included! ;-) I made several different Star-Wars themed plate designs. As promised in my other baseplate thing (Find 6 baseolates here: https://www.thingiverse.com/thing:4802412 ) I made new ones after I got 100 likes, here they are: The Designs/recommended filament color Rebell Logo / Red;White Imperial Logo /Black , White Crimson Dawn Logo / Black, gold Black Sun Logo / black; white For each part there is a inlay which can be printed in a different color, or you can pait the baseplate. Each baseplate consists of the plate with 3 pins on top which are connected with a single layer to the baseplate for easier printing (the little t-shaped pins have no good adhension to the bed if printed alone.) (I added 3 pins per plate but only 2 are needed, the extra one is in the case that one isn´t printed properly) After printing cut away the pins and the connector layer, and press the pins from the underside in the openings in the baseplate, they should fit in with a satiesfying click. Tip: put them in place and place it on a flat hard surface and press from above on the plate till they click in. It took me several optimizations till the pins had the right diameter for the little holes in the feet of the action figures and they clicked to the baseplate properly, but it still depends on the tolerances of your printer. So if the pins don´t hold properly use some glue or a soldering iron. If the Pins are too loose in the feet increase the size by 1 or 2 % (101% 102% upscaing in the slicer) or decrease the size if they don´t fit. I Printed 20+ plates for all of my figures and they all worked fine. Each plate takes approximately 1 hour to print at 0.2mm layers. Print without supports and without brim. Legal stuff: BY DOWNLOADING THE FILES FROM THINGIVERSE YOU AGREE TO THE FOLLOWING TERMS AND CONDITIONS: The files are for private use only! You are allowed to print parts from them for your personal use only! You are not allowed to use this files or parts you printed with the use of this files of it in any comercial way! If you are distributing Pictures from parts or models you build with theses files you are only allowed to to so if you are declaring the source of the design. You have to add a link to this thingiverse-thing in the description of your Fotos! You are not allowed to copy or distribute them in any way! You are not allowed to sell them or parts you printed from them or models you build with the use of this files!