Bass Clef Headphone Stand

thingiverse

Created to hold my computer headset and as a double bass player wanted something unique to me. Ends up about 20cm / 8 Inches tall and Clef is 25mm / ~1 inch wide Prints as 2 pieces for no support printing, that can then slide together easily. Makes for easy assembly/disassembly and flat transport if required. You could of course glue it together should you want it permanent and/or tighten the tolerances on the hole if you just want a tighter fit (I left it fairly loose so wouldn't have to re-print if it was too tight) Remixed from Bass clef: https://www.thingiverse.com/thing:93518 and Makerbot stand: https://www.thingiverse.com/thing:2050885 Printing: I did at 0.3 and 10% cubic as that was good enough for this piece IMHO and wanted it faster. But could do at less if you prefer a finer finish.