Bathroom Soap Holder

thingiverse

This print shall rid you of all those moldy soap holders you have in your shower or bathroom and will clean up and let your soap dry instead of sitting in a pool of water all day and getting soggy! This is an easy print that most printers should be able to do and may require supports around the main object but there aren't any tight tolerances so if pieces do feel a little loose then just put some blue tack or hot glue under them to get them to stay. The drying rack sits in the holder and can be switched out for your own custom inserts and the hook just slides on over the opposite end of where it clicks in. Hope you enjoy this print and it saves you a lot of soap, it should work on just about any size pole but just to make sure you should probably do a rough measure. Make sure to like this object too!