Bathrooom Set: Garbage pail, toothbrush and plunger holder

thingiverse

This is a remix of (1) Garbage Pail https://www.thingiverse.com/thing:4961519, (2) Mason Jar Lid https://www.thingiverse.com/thing:3468220, and (3) Plunger Cover https://www.thingiverse.com/thing:4857200. (1) The garbage pail was resized to 200 x 180 mm to fit on my Flsun Q5. Something funny happened to the last ~ 30 layers (I was printing at 0.3 mm). I've never gone higher than ~ 150 mm before so I don't know what caused the flattening of the rim. I did use lightning infill at 20%. You can see the lightning infill from the bottom using the Twinkling Blue PLA from Enotepad -- it looks really cool and is plenty solid. (2) Four 20 mm holes were cut out of the mason jar lid to accomodate the larger handled toothbrushes. Printed with 100% infill (lines) and 0.2 mm resolution. I had to coat the build plate with glue stick to get the first layer to adhere nicely and achieve a nice finish since that's the public side of the print. (3) The plunger cover was resized to 160/100/150 mm (x/y/z) to better accomodate a standard red 6" toilet plunger. The resizing made the top and bottom sides a little on the thin side (~ 1.8 mm), but my plunger slides in nicely. Printed with 20% infill (lightning) and 0.3 mm resolution. **Note:** I've uploaded a plunger cover with a thicker top and bottom, but have not printed it out. No rafts or support were used, but a two line skirt was needed to get the Enotepad Twinkling Blue to start to consistently adhere to the plate during the build. Print Temp: 220°C; Plate Temp: 70°C.