batman Head

thingiverse

found the original on tinkercad, not sure who did it but its a very good model. original was a lot bigger and had no base so to make it printable I scaled it down and gave it a base, I also angled it back so that the chin was not level to the base so it would print easier. Instructions I printed this at 0.4 layer and only 20% fill and it came out OK. I did not use a raft but the chin and top of the ears are tricky. was going to make another at 0.3 to see how it comes out but not got to it yet. so much to print and so little time :). my son likes it and that's the main thing