BB/pellet gun silencer (suppressor)

thingiverse

i seen a couple different suppressors on here but none were exactly what i was looking for that would fit my gun without using any fasteners. I have the Daisy Powerline 880 pellet/BB gun and the front site doesnt allow for any add ons to the gun without taking the front sight and plastic end barrel off so i added the same configuration to the end of the suppressor so now all you have to do is pull the front sight out which is quite simple. under neath where the barrel is split just pry open slightly with a flat head screw driver and the pull or tap front sight out with pliers. then this suppressor will slide right into place where that front piece was and should align the barrel up like it was stock again. i added a cut away view to see the baffles inside i just used a slicer to show this i didnt know how to other wise. i think the pic only shows 5% infill however i would up that to almost 100%. i didnt print this yet myself cuz i am waiting for some filament as soon as i do print i will post pics then. so im not sure how much this will quiet it down but let me know if you do decided to print this and post a pic if you would. andd if you feel like i did a good job then please feel free to leave a tip to let me know. also im still very new into designing 3D models so if any of you really good designers out there have any tips for me please let me know thanks in advanced.