Bebop 2 upper mount

thingiverse

this is a camera mount that uses a standard mount like Go-pro and some 360/action camera's. The small tabs are situated so as to lock the mount into the old battery strap slots to prevent the mount from sliding fwd and aft. A thin layer of foam may be needed between mount and battery to reduce chances of oscillations. Print Settings Printer: da Vinci 1.1Plus Rafts: No Supports: Yes Resolution: .2 Infill: high Notes: position with thin ramps on upper side to minimize support and increase strength. Part was designed in Catia using SAE measurements so import to slicer in inches not mm.