Becker Ka-Bar BK23 sheath and scales

thingiverse

I just didn't like the skeeton design on this one, so... The larger sheath should fit with a molle type pattern on your backpack or tactical vest. Prints without supports or brim - the large sheath comes with it's own support - just cut that away after print. Use M3 allen-head screws and standard nuts (black, of course ;-) The sheaths are very tight whe you slide in the knife for the first time. Push the knife to the stop, and let it in there over night. It wil be hard to pull out still, but only the first time. After that the fit is perfect. Print Settings Rafts: Doesn't Matter Supports: No Resolution: .2 or better Infill: 15-20%, 25% on the scales Notes: You may need to open the screw holes with a 3.2mm drill bit (1/8")