Witch's Cauldron

thingiverse

#CostumeChallenge2017 This is a witch's cauldron. You can print the support with a witch extending her hand to you to trap you. The cauldron and the support don't need print support, you only need to open the cauldron (pota.stl) and print it to a 99% of its natural size and then print the witch's support in natural size. They are big enough for the printer that I usually use. The witch's support is 130mmx170mmx110mm. The cauldron is 100mm diameter, is perfect for keep your candies. You decide wich is the best filling, but for the witch's support I think that its over 15% the better, for the cauldron is better 25%. The first design was made with the cauldron rotated. This design is with the cauldron ready to print.