Bed Isolation support with springs

thingiverse

Here we are on my first try. This would be an idea for 2 purposes. Using the spring instead of a silicone spacers, which are too hard, for stability and to keep the insulation pad tight on the bed corners. The rear left one, is of course little bit different, and need a modification on cable support. Yellow springs fit with small gap tor educe vibrations. Insulation need to be cropped, better when already on the bed (prevent mistakes), but pay attention not to damage the surface. This should be ok for almost all insulation pad that usually are 10 mm. files are for 2 different set, as at beginning I supposed they start rotating due to vibrations. after some hours in place it never happened. Printed with PETG because it should better resist than PLA to temperature.