Beehive Stand with Leveller and Water Reservoir/Ant Guard

thingiverse

4 Beehive levelers are needed per Beehive (5 if using a liquid other than water) 3 printed components are required for each Bee Hive Leveler. -Nut Turner Guide, which prevents the nut turner from slipping under the hive -Nut Turner which turns a nut that moves up or down a bolt which in turn moves that corner of the hive -Foot, secures a bolt which runs through the hive leveler and supports the weight of the hive. The Pan is the 4th and optional component, which can be replaced by a similar container. -Pan/Reservoir can serve as a water source for the bees and prevents the entry of ants(use veg oil instead of water) -Pan cover is recommended if oil is used Additional required components include a 1/4" diameter, 2" length bolt and nut, and 3 coarse thread self tap-in screws(I used 0.3" head, 1" long coarse thread). ps. longer bolts can be used if a taller stand is required. edit- 03.04.2019 -replaced pan cover for v3 Moat, with one with a slightly larger center hole edit- 24.12.2018 -added combined foot and pan v3 for 1/4" and M6 bolt models, and foot/pan cover(remixed Moat and cover) from here https://www.thingiverse.com/thing:781265 edit- 20.09.2018 -added pan_cover -added combined foot and pan v2 for 1/4" bolt model (to use with pan_cover) edit- 12.06.2018 -added combined foot and pan for both M6 and 1/4" bolt models (pan height reduced and diameter increased, foot height increased) -added revised nut_turner for both M6 and 1/4" models edit- 08.04.2018 -added foot and nut_turner stl for M6 bolt and nut NB. I noticed some slight movement of the bolt inside the foot after installation(maybe rocking caused by moving hives during inspection and even wind). You should consider increasing infill % when printing Hive_Foot and newly introduced Hive_Foot_with_Pan_combined. Thank you for your show of support and appreciation of this Thing. Optional tips this way - https://www.paypal.me/Zandoli3D