Beer Tap Handle for Keg Cap

thingiverse

I've seen several tap handles similar to this, I just made my own version. It prints in two parts easily. The top will fit into the hole on the top of the bottom piece (very tight, so no glue needed; maybe need to sand it down a tad). The plastic cap off of the keg will fit right on the fact of the round top. It's a little bit loose, so I might adjust the diameter a bit, but it's just fine the way it is now. The threads on the bottom are modeled into the piece and I was able to screw it right onto the tap without even cleaning them (no supports).