Beetle micro quadcopter frame (brushed motors)

thingiverse

My take on a Quadcopter frame. It's intended for 8.5x20mm coreless motors and a micro F3 flight controller. I have yet to buy the parts so the design may change to accommodate the electronics. Design was based on looking around at different quad frames and I liked a sort of hybrid X frame quad with an organic look. I think it looks a bit like a beetle so that is where the name came from. Parts needed. 4x m3 nylon screws 4x m3 20mm standoffs (spacer) 4x m3 6mm standoff (column) or hex nuts or screws (I went with the standoff to provide some feet for the quadcopter 4x rubber grommet for motor mounts (https://www.banggood.com/20pcs-Rubber-Wiring-Grommets-Ring-Cable-Protector-5678mm-Inner-Dia-p-1070122.html?X709229380619201703O Flight controller: Micro 32 bits F3 brushed board https://www.banggood.com/Micro-32bits-Brushed-Flight-Control-Board-Based-On-SP-RACING-F3-EVO-Brush-For-Micro-FPV-Frame-p-1070068.html?X709229380619201703O You can find these with and without a receiver attached. I have a Flysky i6x transmitter and am buying a separate rx for the above board. Brushed motors: 8.5x20mm coreless https://www.banggood.com/4X-Chaoli-CL-820-8_5x20mm-Coreless-Motor-for-90mm-150mm-DIY-Micro-FPV-RC-Quadcopter-Frame-p-1069067.html?X709229380619201703O Propellors: 55mm props take your pick https://www.banggood.com/search/55mm-propeller.html?X709229380619201703O Optional: FPV camera: Eachine Tx01 https://www.banggood.com/Eachine-TX01-Super-Mini-AIO-5_8G-40CH-25MW-VTX-600TVL-14-Cmos-FPV-Transmitter-p-1088374.html?X709229380619201703O