Belt Holder - Obi-Wan Kenobi Light Saber

thingiverse

I have an Obi-Wan costume and needed a good way to hang the light saber on my belt. It worked out very well. Standing and walking I did not have a problem with it. Bending down and crouching the light saber hit my leg and would lift out of the holder, so just keep that in mind when using this. The first change was the lower chamber did not have the hole for the button square to the outside. This was changed to allow for better button placement. If you already have your light saber done then you can probably get away with the one you have with a bunch of glue. The "button" was modified to have the proper spacing for the pla holder that goes on the belt. The button center still needs to be printed from the original design. The third part is the belt piece. It was designed to go around the belt that I had. You may need to modify it depending on the belt you choose to use with it. I printed the belt piece solid with no infill to give it a little more strength. This led to a gap at one of the ends where the printer didn't cover between the layers. A bit of glue and it was ok, but you may want to try a fill percentage, but not solid, to avoid this.